The Modern Blocky Black Leather Three-Seater Sofa with Grey Arm Accent from LELE Furniture, model LTHR-SOFA-3S-BLK-GRY, presents a streamlined, minimalist silhouette defined by its low-profile floor-resting block base, which is upholstered in matching black leather over a rigid wood frame and fitted with floor protection glides with no exposed legs. Wide padded armrests frame both ends, finished with a matte grey accent panel that adds subtle visual contrast against the full-grain black cowhide leather upholstery. Segmented tufted seat cushions and curved ergonomic segmented backrests create a clean, structured layout aligned with modern interior aesthetics, with individual fixed seating positions to support consistent alignment and comfort. The sofa is built for long-term residential and light commercial use, with a kiln-dried solid pine wood inner frame of 30mm section thickness, constructed with reinforced polyester thread seams stitched at 8 stitches per inch. The outer upholstery uses 1.4mm thick full-grain black cowhide, with armrest accents available in matte grey faux leather or painted composite trim. Seat cushions are filled with high-density polyurethane foam wrapped in a 20mm down layer, while back cushions use 35kg/m³ polyurethane foam with a polyester fiber wrap, supported by 80mm wide sinuous steel springs paired with 50mm elastic webbing. The leather surface delivers 50000 cycles of abrasion resistance, the frame joint static load durability reaches 10000 cycles, and total static load capacity is 300 kg, supported by foam with a 60% rebound rate. This non-reclining sofa features fixed upright backrests with no manual or powered recline mechanisms, with fixed cushion attachment to prevent shifting. The smooth leather surface allows simple wipe-clean maintenance for regular household use, and it comfortably seats 3 average adults for daily relaxed seating. Overall dimensions measure 2200 x 1000 x 880 mm, with a 420 mm seat height, 580 mm seat depth per position, 620 mm seat width per position, 620 mm armrest height, 200 mm armrest width, 460 mm backrest height above the seat, and 120 mm base height. Ideal for residential living rooms as primary casual family seating paired with a coffee table, it also fits modern open-plan apartments and small office or club lounge reception areas, with a recommended layout pairing it with an 1100 mm diameter coffee table and area rug for visual balance. Procurement teams should note the unit ships in 2 cartons per set, with 40 minutes of assembly time per unit, a packaged gross weight of 110 kg, 1.8 m³ packaging volume per item, and a 1 year warranty period. The unit is a single straight fixed piece with no sectional connector points, so layout planning should account for its non-modular design.