The Green Upholstered Low-Back Bolster Dining Chair is a modern armless seating piece defined by a round seat and a continuous horizontal cylindrical back. Its green velvet-like woven upholstery creates a soft, sculptural appearance, while the low bolster gives the chair a compact visual profile without enclosing the sitter. Four black cylindrical metal legs and two matching rear support posts establish a clean green-and-black contrast suited to contemporary interiors. The single-seat design measures 520 millimeters wide, 540 millimeters deep and 760 millimeters high, with a 470 millimeter seat height and a 480 millimeter round seat. The fixed bolster back rises 250 millimeters above the seat and provides lumbar-level support rather than full-height back support. It does not recline, swivel, tilt or adjust in height. Beneath the tailored upholstery, the seat uses a 120 millimeter polyurethane foam cushion over a concealed poplar plywood support board. The seat foam density is 35 kilograms per cubic meter, while the bolster combines high-resilience cold foam with a secondary polyurethane layer. The back contains a bent plywood or timber insert, and the chair rests on matte black powder-coated metal tubes fitted with black polymer snap-in glides intended to protect hard flooring. The armless open-front layout supports entry from both sides and allows the chair to be pulled close to a table or counter edge. With a recommended user load of 136 kilograms, it is practical for dining and occasional seating, though the fixed low-back form is better suited to social and short-duration use than full-time task seating. It is non-stackable and supplied without casters or a gas lift. The chair works well at standard-height dining tables and along open kitchen islands. It can also serve as a vanity seat in a bedroom, an accent chair in a hotel guest room, or occasional seating beside a compact home-office desk. In light hospitality settings, chairs can be grouped around small bistro tables in waiting or lounge areas. Procurement teams should plan for knock-down assembly using threaded fasteners and allow about 40 minutes per set. Each set is supplied in two cartons with a packaged gross weight of 23 kilograms. The low, armless silhouette is advantageous where visual openness is desired, while replacement glides and consistent floor protection should be considered for high-use hard-floor installations.