The LWS-NAP160-FB is an unbranded L-shaped single cubicle workstation that combines a private work surface with a concealed pull-out folding nap bed. Its two-sided rear and side privacy panels create an enclosed feel while keeping the front open for access, and the curved inner cutout provides central leg room between the desktop wings. The light oak-look engineered wood surfaces are paired with gray woven fabric panels, white and light gray lower panels, and a white powder-coated steel frame, giving the workstation a coordinated neutral appearance suited to organized commercial interiors. The worktop and cabinet use engineered wood board with a light oak-look melamine surface and sealed edges. Privacy panels consist of gray woven fabric over composite panel with a silver-toned edge frame, while lower modesty panels use hard laminated engineered board. The desk is supported by white powder-coated square steel legs and horizontal rails. The integrated bed uses a welded steel tube frame with transverse support bars, a steel slat or cross-bar platform, folding drop legs, and a gray segmented polyurethane mattress in a woven textile cover. Black polyurethane twin-wheel swivel casters with steel mounting brackets support smooth movement. For daily work, the L-shaped layout gives one person room for a monitor, documents, and task-related equipment, while a rear cable grommet routes power and monitor cables below the surface. When rest is needed, the three-section bed slides horizontally from the left under-desk cabinet. The mattress sections unfold longitudinally, and the drop legs support the platform on the floor. After use, the bed folds back into its dedicated cabinet bay and is hidden behind a matching hinged wood door. Swivel corner casters and intermediate caster supports allow the bed to be extracted and parked by one person. This configuration is suitable for open-plan offices that need a daytime nap station without a separate dormitory, as well as control rooms, medical offices, duty rooms, and other 24-hour operating environments. It also fits single-person cubicle layouts, government or enterprise staff areas, space-efficient office planning, and quiet hybrid-office corners where occasional overnight work may occur. By integrating desk, privacy screening, cable routing, storage, and bedding in one footprint, it reduces the need to specify separate furniture pieces. Procurement teams should plan around delivery as a multi-carton set and allow time for on-site assembly. The specified static loads, caster load rating, folding-cycle rating, foam density, and single-user capacity should be matched to the intended use pattern. Projects should also verify room circulation space, floor surface suitability, cabinet access, and the clearance required to pull out and lower the bed fully.