The Nested Round Coffee Tables with White Fluted Base and Amber Glass Top form a contemporary two-piece seating-area set with a soft sculptural profile. The larger table combines a cylindrical white fluted body with a circular white marble-look top featuring gray veining and a polished finish. A thin matching white edge band or painted rim defines the top, while the centered pedestal design leaves the perimeter open without four corner legs. The smaller table uses an amber-tinted transparent glass top with a smooth polished circular edge, supported by a white painted cylindrical column and round base plate with a slightly raised foot rim. In the nested arrangement, the glass table overlaps the larger circle to create a layered, two-level display and serving composition; as separate freestanding pieces, the tables can also be pulled apart for sofa-side or corner placement. Construction is based on a white painted engineered-wood or MDF body for the large table, with continuous vertical fluting formed over machined ribs and finished in smooth matte white paint or laminate. The marble-look surface is an engineered stone-look panel, while the smaller tabletop is specified as tempered safety glass. Both tables use painted pedestal support structures, and non-marking floor-protector pads are recommended under the bases. The set has no drawer, shelf, hinged compartment, cable port, or power module, so it is suited to decorative serving use rather than storage or electrified applications. Functionally, the larger low table provides the principal surface for trays, books, remote controls, and drinks, while the raised amber-glass top offers a visible accent zone for a lamp, vase, or sculptural object. The configuration is intended for four simultaneous users and is appropriate in modern living rooms, lounge and reception seating, show suites, hotel executive lounges, small breakout areas, and bedroom sitting corners. It works especially well where a refined focal point is more important than heavy utility storage. Procurement teams should note that this unbranded model is supplied as one set in two cartons, with assembly time given as 40 minutes per set. The recommended total set weight is 48 kg, while packaged gross weight is listed as 90 kg per set. Planning should account for two separate pedestal floor-contact points and the need to position the pieces for balanced access. The marble-look surface should remain within a 60 degrees C service temperature, and distributed load guidance should be observed for both the large top and the smaller glass top.