Rectangular Solid Wood Top Dining Table with Black Metal Trestle Legs This unbranded fixed rectangular trestle dining table, model DT-MW1800-TRESTLE, carries a clean industrial aesthetic defined by the contrast between its warm wood top and sleek matte black metal base. The layout follows a classic trestle structure, with two supporting leg units joined by a welded longitudinal cross beam, leaving an open under-table zone that delivers 680 mm of height and 900 mm of width of knee clearance per main seating position, with enough open space to accommodate two seats on each long side and one seat at each short end for a total of six guests. Four evenly placed floor contact points give the base a balanced visual profile. The tabletop is offered in natural oak veneer or solid pine, finished with three coats of low-VOC clear matte nitrocellulose lacquer for a smooth, sealed surface. It features straight square edges with lightly sanded rounded corners, with a finished top thickness of 45 mm; load-bearing top builds use a 40 mm composite structure with 25 mm primary panels and 2 mm edge banding. The support frame is constructed from 1.5 mm thick square steel tube with a matte black powder coating, with 80 mm main leg sections built from 2 mm wall steel, and 40x40 mm welded cross supports for torsional stability. M8 steel carriage bolts secure the frame to pre-installed threaded inserts on the tabletop underside, and 3 mm thick non-slip PE pads at each leg base protect floors from scratches. The table supports a 150 kg uniformly distributed static load across the top, with a 100 kg static load rating per leg joint, and the wood surface withstands 10,000 rub cycles for long-term wear resistance. An integrated 80 mm diameter cable opening leads to a 120 mm deep cable tray that holds 10 power or data cables with a 10 kg load capacity. The welded cross support reduces frame wobble on floors with up to 3 mm of unevenness, and the sealed wood surface wipes clean easily with mild household cleaners without water damage. The table is suitable for residential dining rooms supporting daily family meals and casual gatherings, open-plan kitchen dining areas where its industrial style coordinates with modern, rustic, or loft design schemes, small office break rooms for employee meals and casual meetings, and high-traffic cafe or bistro settings where its durable easy-clean surface holds up to regular use. For procurement, note the unit ships knock-down in two cartons with all required hardware included, with a 40-minute reference assembly time per set. Packaged sets have a gross weight of 90 kg and 0.55 m³ volume, with packages measuring 2100×1100×300 mm, and the assembled unit weighs 48 kg.